Driver assistance system
647
Smart Cruise Control (SCC)
To turn on Smart Cruise Control
Press the Driving Assist ( ) button to
turn on the function. The speed will be
set to the current speed on the cluster.
僅 If there is no vehicle in front of you,
the set speed will be maintained.
僅 If there is a vehicle in front of you, the
speed may be adjusted to maintain
the distance to the vehicle ahead. If
the vehicle ahead accelerates, your
vehicle will travel at a steady cruising
speed after accelerating to the set
speed.
If your vehicle speed is between 0~20
mph (0~30 km/h) when you press the
Driving Assist ( ) button, the set speed
will be set to 20 mph (30 km/h).
To set vehicle distance
Each time the button is pressed, the
vehicle distance changes as follows:
僅 If you drive at 56 mph (90 km/h), the
distance is maintained as follows:
- Distance 4 - approximately 172 ft.
(52.5 m)
- Distance 3 - approximately 130 ft.
(40 m)
- Distance 2 - approximately 106 ft.
(32.5 m)
- Distance 1 - approximately 82 ft. (25
m)
僅 The distance is set to the last set dis
-
tance when the vehicle is restarted, or
when Smart Cruise Control was tem
-
porarily canceled.
To increase set speed
Push the + switch up and release it
immediately. The set speed will increase
by 1 mph (1 km/h) each time the switch
is operated in this manner.
僅 Push the + switch up and hold it. The
set speed will increase by 5 mph (10
km/h) each time the switch is oper
-
ated in this manner.
僅 You can set the speed to 110 mph
(180 km/h).
Check the driving condition before using
the + switch. Driving speed may sharply
increase when you push up and hold the
+ switch.
To Next Page
Loading...
