Electric vehicle guide
121
EV menu
and display a warning message. Make
sure that the total power consumption of
your electrical appliance does not
exceed the V2L maximum power output.
V2L conditions not met
1 V2L conditions not met
If V2L is interrupted for any of the fol
-
lowing reasons, a this message is dis
-
played.
僅 V2L connector switch off
僅 V2L connector overheating
僅 Opening the charging door while
using the V2L indoor outlet
Make sure there are no problems with
the V2L connector or the vehicle Inside
outlet.
僅 Do not touch the V2L connector or the
terminal of the vehicle charging hole
僅 Do not put metal objects to the V2L
connector or charging hole. It might
be a cause of electric shock.
僅 Do not touch the V2L connector,
charging hole or power plug with a
wet hand. It might be a cause of elec
-
tric shock. Please handle with a dry
hand all the time.
僅 Confirm whether there is foreign sub
-
stance such as water or dust on the
V2L connector, charging hole or
power plug before connecting. If you
connect it with foreign substances, it
may be a cause of fire or electric
shock.
僅 Do not modify or disassemble the V2L
connector. There is a risk of fire, elec
-
tric shock or injury.
僅 Do not charge under the following
conditions as doing so can cause
injury:
- The V2L connector, charging hole,
power plug or cable is damaged,
corroded or rusted.
- The connection is not secure.
僅 Do not use If the cord of an electrical
appliance is damaged or broken.
There is a risk of fire, electric shock or
injury.
僅 Never use an electric heating appli
-
ance like iron, coffee pot, or toaster in
the vehicle. It may cause a fire and
injury.
僅 Be well-informed of the manual to
prevent accidents.
僅 The V2L discharging mode is blocked
automatically in case of overheating.
(When the discharging mode is
blocked, check whether the V2L con
-
nector or power plug is contaminated,
worn, corroded or broken or the home
appliance capacity is over 16 A. If the
temperature falls to proper level after
it is left unattended, you can use it
again. Use proper home appliances.)
僅 Do not modify or disassemble the V2L
connector. Failure caused by modify
-
ing or disassembling is not covered by
the warranty.
僅 Do not drop or hit the V2L connector.
僅 Do not place objects on the V2L con
-
nector.
To Next Page
Loading...
