Features of your vehicle
1145
Lighting
Auto light
When the light switch is in the AUTO
light position, the taillamps and head
-
lamps will turn ON or OFF automatically
depending on the amount of light out
-
side the vehicle.
僅 Never place anything over the sensor
(1) located on the instrument panel as
this will ensure better auto-light sys
-
tem control.
僅 Don't clean the sensor using a window
cleaner. The cleaner may leave a light
film which could interfere with sensor
operation.
僅 If your vehicle has window tint or
other types of metallic coating on the
front windshield, the Auto light system
may not work properly.
Operating high beam
To turn on the high beam headlamp:
僅 Push the lever away from you.
The lever will return to its original
position.
The high beam indicator will light
when the headlamp high beams are
switched on.
High beams
Do not use high beam when there are
other vehicles in front of or approaching
your vehicle. Using high beam could
obstruct other drivers’ vision.
To flash the headlamps:
僅 Pull the lever towards you.
It will return to the normal (low beam)
position when released. The head
-
lamp switch does not need to be on to
use this flashing feature.
Operating turn signals and lane
change signals
The ignition switch or EV button must be
on for the turn signals to function.
To turn on the turn signals:
僅 Move the lever up or down (A).
The green arrow indicators on the
instrument panel indicate which turn
signal is operating.
To Next Page
Loading...
