Driver assistance guide
587
Blind-Spot View Monitor (BVM)
Blind-Spot View Monitor settings
Blind-Spot View
1 Driver Assistance
2 Driving Safety
3 Blind-Spot View Monitor
With the vehicle on, select
Setup
→
Vehicle
→
Driver Assistance
→
Driving
Safety
→
Blind-Spot View Monitor
from the infotainment system screen to
turn on Blind-Spot View Monitor and
deselect to turn off the function.
Blind-Spot View Monitor opera
-
tion
Turn signal lever
Blind-Spot View Monitor will turn on and
off when the turn signal is turned on and
off.
Blind-Spot View Monitor
Operating conditions
僅 When the left or right turn signal turns
on, the image on the instrument clus
-
ter will turn on.
Off conditions
Blind-Spot View Monitor will turn off
when one of the following conditions are
satisfied:
僅 When the turn signal is turned off.
僅When the hazard warning flasher is
on.
僅 When other important warning is dis
-
played on the instrument cluster.
Blind-Spot View Monitor mal
-
function
When Blind-Spot View Monitor is not
working properly, or the cluster display
flickers, or the camera image does not
display normally, have Blind-Spot View
Monitor be inspected by a professional
workshop. Visit an authorized Kia dealer.
僅 Blind-Spot View Monitor may display
objects at a different distance from
what is shown on the screen due to
the correction of the wide-side view
camera images. Make sure to directly
check the vehicle's surroundings for
safety.
僅 If the camera lens is covered with for
-
eign material, Blind-Spot View Moni
-
tor may not operate normally.
Always keep the camera lens clean.
However, do not use chemical sol
-
vents such as strong detergents con
-
taining high alkaline or volatile
organic solvents (gasoline, acetone
etc.). This may damage the camera
lens.
To Next Page
Loading...
