Safety features of your Kia
144
Seat
Non-operating condition(s)
僅 When the vehicle is in R (Reverse)/N
(Neutral)/D (Drive) position
僅 When the vehicle speed is above 3
km/h (2 mph)
僅 When the driver position memory sys
-
tem needs initialization
Resetting relaxion comfort seat
Driver's side
1. Open the driver's side door when the
vehicle is stopped and the vehicle in
ON position.
2. Move the seat forward as far as possi
-
ble, and raise the seatback angle as
forward as possible by using the
driver's seat forward/backward
adjustment switch and seatback angle
adjustment switch.
3. Press the
Driver 1
switch (1) from the
driver position memory system and
push the front portion of the driver's
seat forward/backward adjustment
switch (the direction to move the seat
position forward) at the same time for
approximately 2 seconds.
Make sure there are no obstacles
around the driver's seat before initializa
-
tion.
The initialization process are as fol
-
lows.
1. With a beep sound, the initialization
process begins.
2. The seat and backrest automatically
move to the rear. A beep sounds con
-
tinuously during operation.
3. The seat and backrest will move to
the center again and the initialization
process will end with the last beep
sound.
Non-operating condition(s)
The initialization process will be inter
-
rupted in the following situations.
僅 When any problem occurs in the
driver position memory system
僅 When the driver position memory sys
-
tem button is pressed
僅 When the driver's side seat adjust
-
ment switch is pressed
僅 When the vehicle speed is above 3
km/h (2 mph)
僅 When the driver's side door is closed
僅 If the driver's seat operation and a
beep sound stop during initialization,
start initialization again.
僅 After initialization, adjust the seat to
suit the driver and save it to the driv
-
ing position memory system again.
To Next Page
Loading...
