Vehicle controls
OMV053100R
1 Door handle authentication pad,
2 Card key NFC antenna
Locking/Unlocking the doors
• If the driver touches the NFC antenna of the registered card key 2 on the driver's or
passenger's door handle authentication pad (1) for more than 2 seconds, the door
will lock or unlock.
• After locking the door, make sure to check its locked state. After unlocking the
doors, the doors will automatically re-lock after 30 seconds unless a door is opened.
• It works only if the centre of the NFC card key is accurately touched to the NFC au
thentication area of the vehicle door handle.
NOTE
When approaching smartphone NFC antenna to the centre of the outside door handle
authentication pad, the doors will not lock with a beep sound in following conditions:
• When the Smart Key is in the vehicle
• When the EV button is in ACC or ON position
• When one or more doors, bonnets or tailgates are open
Starting the vehicle
After placing your registered card key 2 on the in-vehicle authentication pad (wireless
charger pad), depress the brake pedal and press the EV button to start the vehicle.
• Once the vehicle is started, you can remove the card key from the pad.
For more details, refer to "EV button" on page 419
WARNING
The vehicle can be started when the registered card key is placed on the in-vehicle
authentication pad (wireless charging pad). Therefore, do not leave unsupervised chil
dren or people who are not aware of the system since it can result in serious injury
or death. In addition, always have the registered card key with you to prevent vehicle
theft when leaving the vehicle.
230
To Next Page
Loading...
