Vehicle controls
Electric type (if equipped)
Operation
• Adjust the steering wheel angle (2) and position (3) with the switch (1).
Never adjust the position of the steering wheel whilst driving.
WARNING
• Never adjust the angle and height of the steering wheel whilst driving. You may lose
steering control and cause severe personal injury, death or accidents.
• After adjusting, push the steering wheel both up and down to be certain it is locked
in position.
• If the steering wheel becomes too warm, turn the system off. The heated steering
wheel may cause burns even at low temperatures, especially if used for long peri
ods of time.
CAUTION
• Do not install any type of grip cover for the steering wheel, it may impair the func
tion of the heated steering wheel system.
• When cleaning the heated steering wheel, do not use an organic solvent such as
paint thinner, benzene, alcohol and petrol. Doing so may damage the surface of the
steering wheel.
• If the surface of the steering wheel is damaged by a sharp object, damage to the
heated steering wheel components could occur.
• Do not strike the horn severely to operate it, or hit it with your fist. Do not press on
the horn with a sharp-pointed object.
• When cleaning the steering wheel, do not use an organic solvent such as thinner,
benzene, alcohol and petrol. Doing so may damage the steering wheel.
NOTE
• Be sure to adjust the steering wheel to the desired position before driving.
• After adjustment, sometimes the lock-release lever may not lock the steering wheel.
It is not a malfunction. This occurs when two gears engage. In this case, adjust the
steering wheel again and then lock the steering wheel.
• The following symptoms may occur during normal vehicle operation:
◦ The EPS warning light does not appear.
◦ The steering effort is high immediately after pressing the EV button to ON posi
tion. This happens as the EPS system performs the diagnostics. When the diag
nostics is completed, the steering effort will return to its normal condition.
◦ A click noise may be heard from the EPS relay after EV button is in ON position.
◦ Motor noise may be heard when the vehicle is at a stop or at a low driving speed.
298