Vehicle controls
• When shifting from R (Reverse) to N (Neutral) or driving at a speed of about 10
km/h (6 mph) or more after shifting to D (Drive), the normal view is switched.
• The wide view works only when the DSM monitor screen switching function is used
when reversing, and the general view works in P (Parking), N (Neutral), D (Driving)
positions.
Operation
OMV033027R
• Select L (driver's seat) or R (passenger's seat) with the DSM camera control selection
lever (1).
• When shifting to the R (Reverse) position, both DSM monitors switch to wide view.
• When the DSM camera control select lever (1) is placed in the centre position, both
DSM monitors will not switch to wide view.
CAUTION
If there is a problem with the digital side mirror, the screen will not be displayed on
the DSM monitor and the warning message Please check DSM system will be dis
played in the cluster. At this time, check the surroundings with the rear side monitor
screen displayed on the cluster and the interior mirror when the turn signal is operat
ed, immediately stop in a safe place, and we recommend that you have your vehicle
inspected by an authorised Kia dealer/service partner.
Adjusting the DSM brightness
• When the vehicle is in ON position, select Settings > Display > Brightness from the
infotainment system.
• The brightness can be adjusted automatically or manually.
DSM mirror defogging
• Select rear windscreen defrosting button when the vehicle is in ON position.
314
To Next Page
Loading...
