Tyre Mobility Kit (if equipped)
• Connecting the (+) terminal and (-) terminal the on wrong sides may cause damage
to the 12V battery and the TMK. Connect the cables according to the specified or
der.
• When disconnecting the cables, always disconnect the (-) terminal (black cable)
from the battery first.
• Do not connect another vehicle's Tyre Mobility Kit (TMK) to the power outlet or bat
tery terminal. The unmatched power requirement between the vehicle power outlet
and the tyre mobility kit can cause fire or circuit damage within the vehicle and the
Tyre Mobility Kit.
Checking tyre inflation pressure
OMV063008
Operation
1. After injecting the sealant, drive the vehicle for approximately 7-10 km or about 10
minutes, and then park in a safe place.
2. Connect the compressor and the tyre connection hose directly to the tyre valve.
3. Connect the 12V battery connector/cable to a 12V battery.
4. Refer to the "Tyres and Wheels" section on page 8-3 or the "Vehicle certification la
bel" and "Tyre specification and pressure label" on page 8-6 to check the tyre pres
sure and adjust it to the specified pressure.
5. To increase the tyre pressure, turn on the compressor and adjust the pressure to
the specified tyre pressure.
6. To decrease the tyre pressure, turn the tyre pressure adjustment knob to adjust to
the appropriate tyre pressure.
7. To check the current tyre pressure, temporarily turn off the compressor
733
To Next Page
Loading...
