Replacing components
• When aiming the low beam, vertical aiming should be adjusted after adjusting the
horizontal aiming.
• Disengage the parking brake and put the gear in N (Neutral), in addition, if head
lamp levelling device is equipped, adjust the headlamp levelling device switch to '0'.
Head lamp low beam (RHD Vehicle)
Based on 10m screen
OMV093051L
A: Vehicle axis
B: Vertical line of the left head lamp bulb centre
C: Vertical line of the right head lamp bulb centre
D: Horizontal line of head lamp bulb centre
E: Ground
F: Cut-Off line
Operation
• Turn the low beam on without driver aboard.
• The cut-off line should be projected in the cut-off line shown in the picture.
• When aiming the low beam, vertical aiming should be adjusted after adjusting the
horizontal aiming.
• Disengage the parking brake and put the gear in N (Neutral), in addition, if head
lamp levelling device is equipped, adjust the headlamp levelling device switch to '0'.
813
To Next Page
Loading...
