517
Driving your vehicle
(Continued)
• When the stop lamp fuse is blown,
you cannot start the engine nor-
mally.
Replace the fuse with a new one. If
it is not possible, you can start the
engine by pressing the engine
start/ stop button for 10 seconds
while it is in the ACC position. The
engine can start without depress-
ing the brake pedal. But for your
safety always depress the brake
pedal and clutch pedal (if equipped)
before starting the engine.
Stopping the engine
(Manual Transmission)
1. Make sure the vehicle is complete-
ly stopped and keep the clutch
pedal and brake pedal depressed.
2. Shift the transmission into Neutral
while depressing the clutch pedal
and brake pedal.
3. Engage the parking brake while
depressing the brake pedal.
4. Turn the ignition key to the LOCK
position and remove it.
CAUTION
• Do not press the engine
start/stop button for more
than 10 seconds except when
the stop lamp fuse is blown.
• Do not turn the ignition switch
to the START position with the
engine running. It may dam-
age the starter.
To Next Page
Loading...
