FORTE FEATURES & FUNCTIONS GUIDE
16
*IF EQUIPPED
Turn Signals & Fog Lights*
To operate:
• Turn Signals - Move lever Up/Down for Right/
Left Turn Signal
• Slightly move lever up/down to activate One-
Touch Lane Change Signal
• Fog Lights - Rotate switch to turn Fog Lights
ON/OFF
REMINDER: Headlights must be ON for Fog Light operation.
One-Touch Lane Change Signal is activated by
briefly pressing the Turn Signal lever up or down
and then releasing. The lane change signal will
blink 3-7 times.
To change how many times the Lane Change Signal
blinks (3/5/7), go to User Settings Mode in the LCD
Instrument Cluster modes.
For more information on the User Settings Mode, please refer to
your Owner’s Manual.
For illustrative purposes only. Your actual display, buttons and/or
features may vary.
Windshield Wipers & Washers
Wiper Service Mode
To operate:
• Move lever Up/Down to change Wiper modes
• Rotate INT switch to adjust Intermittent Wipe Speed
• Pull lever to spray and wipe
To inspect or replace the windshield wiper blades to prevent damaging the hood, the blades need
to be moved to the service position
A
.
With the ignition ON, then turning the engine OFF, within 20
seconds move the wiper switch to the MIST position
B
and
hold the switch for more than two seconds until the wiper
blade is in the fully up position.
To return wipers to normal position, turn the ignition ON, then
activate MIST.
• Rotating INT switch up increases Intermittent wipe frequency and wipe
speed. Rotating INT switch down decreases frequency of wipes.
• Set the wiper to OFF position when the wiper is not in use
QUICK TIPS
MIST: Single wipe
OFF: Wiper off
INT: Intermittent wipe
LO: Slow wipe
HI: Fast wipe
One-Touch
Lane Change
Front Fog
Light Control
B
A
Wiper Service Mode
Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website.
Refer to page 2 for more
information.
www.youtube.com/KiaFeatureVideos
QR CODE
STEERING WHEEL CONTROLS
To Next Page
Loading...
