EasyManua.ls Logo

Kia FORTE 2022 - 僅 Stopping the Engine

Kia FORTE 2022
514 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
5
5
Driving your vehicle ENGINE START/STOP button
WARNING
The engine will start, only when the
smart key is in the vehicle. Never allow
children or any person who is unfamiliar
with the vehicle touch the ENGINE
START/STOP button or related parts.
CAUTION
If the engine stalls while the vehicle is in
motion, do not attempt to move the shift
lever to the P (Park) position. If the traffic
and road conditions permit, you may put
the shift lever in the N (Neutral) position
while the vehicle is still moving and
press the ENGINE START/STOP button
in an attempt to restart the engine.
NOTICE
If the battery is weak or the smart key
does not work correctly, you can start
the engine by pressing the ENGINE
START/STOP button with the smart
key. The side with the lock button
should contact the ENGINE START/
STOP button directly. When you press
the ENGINE START/STOP button
directly with the smart key, the smart
key should contact the button at a
right angle.
When the stop lamp fuse is blown,
you can't start the engine normally.
Replace the fuse with a new one. If it
is not possible, you can start the
engine by pressing the ENGINE
START/STOP button for 10 seconds
while it is in the ACC position. The
engine can start without depressing
the brake pedal. But for your safety
always depress the brake pedal and
clutch pedal (if equipped) before
starting the engine.
CAUTION
Do not press the ENGINE START/
STOP button for more than 10 sec
-
onds except when the stop lamp fuse
is blown.
Do not turn the ignition switch to the
START position with the engine run
-
ning. It may damage the starter.
Stopping the engine
Manual Transmission
1. Make sure the vehicle is completely
stopped and keep the clutch pedal
and brake pedal depressed.
2. Shift the transmission into Neutral
while depressing the clutch pedal and
brake pedal.
3. Engage the parking brake while
depressing the brake pedal.
4. Turn the ignition key to the LOCK
position and remove it.
OBD051002

Table of Contents

Related product manuals