103
5
5
Driving your vehicle Smart Cruise Control (SCC)
僅 If your vehicle speed is between 0~30
km/h (0~20 mph) when you press the
Driving Assist button, the Smart
Cruise Control speed will be set to 30
km/h (20 mph).
僅 If driver shifts to a lower gear, the
driving speed may not reach the set
speed.
Setting Vehicle Distance
Each time the Vehicle Distance button is
pressed, the Vehicle Distance changes
as follows:
僅 If you drive at 90 km/h (56 mph), the
distance is maintained as follows:
- Distance 4 - approximately 52.5 m
(172 ft.)
- Distance 3 - approximately 40 m
(130 ft.)
- Distance 2 - approximately 32.5 m
(106 ft.)
- Distance 1 - approximately 25 m (82
ft.)
僅 The distance is set to the last set dis
-
tance when the engine is restarted, or
when Smart Cruise Control was tem
-
porarily canceled.
Increasing set speed
僅 Push up the + switch, and release it
immediately. The set speed will
increase by 1 km/h (1 mph) each time
the switch is operated in this manner.
僅 Push up the + switch, and hold it while
monitoring the set speed on the clus
-
ter. The set speed will increase by 10
km/h or 5 mph each time the switch is
operated in this manner. Release the
switch when the desired speed is
shown, and the vehicle will accelerate
to that speed. Speed cannot be set
below 180 km/h (110 mph).
Check the driving condition before using
the + switch. Driving speed may sharply
increase when you push up and hold the
+ switch.
To Next Page
Loading...
