EMA - 34 ENGINE MECHANICAL SYSTEM
17. Install oil pump chain tensioner assembly(A).
Tightening torque
9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
A
KDRF119A
18. Pull out the pins of hydraulic tensioner (LH ＆ RH).
19. Ins
tall oil pump chain cover(A).
Tightening torque
9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
A
KDRF185A
20. Afte r r otating crankshaft 2 revolutions in regular direc-
tion(clockwise viewed from front), confirm the timing
mark.
NOTE
Always turn the crankshaft clockwise.
21. Install timing chain cover.
a. The sealant locations on chain cover and on
counter parts (cylinder head, cylinder block, and
lower oil pan) must be free of engine oil and
ETC.
b. Before assembling the timin g chain cover, the liq-
uid sealant TB1217H should be applied on the
gap between cylinder head and cylinder block
The pa rt must be assembled within 5 minutes
after sealant was applied.
Bead width : 2.5mm(0.1in.)
KDRF134A
c. After applying liquid sealant TB1217H on timing
chain cover.
The pa rt must be assembled within 5 minutes
after sealant was applied.
Sealant should be applied without discontinuity.
Sealant should also be applied all around the two
holes of t he dowel pins.
Bead width : 2.5mm(0.1in.)
1 0.5mm
1
0.5mm
*
*
*
*
Sealant *
*
*
*
*
*
*
*
*
*
*
*
SBLM16200L
To Next Page
Loading...