EasyManua.ls Logo

Kia K4 2025 - 僅 Window Opening and Closing

Kia K4 2025
490 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
4
4
Features of your vehicle Windows
The ignition switch or ENGINE START/
STOP button must be in the ON position
for power windows to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock button
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 3
minutes after the ignition switch or
ENGINE START/STOP button turned to
the ACC position. If the front doors are
opened, the power windows cannot be
operated even within the 3 minutes
period.
The driver's door has a master power
window switch that controls all the win
-
dows in the vehicle.
If the window cannot be closed because
it is blocked by objects, remove the
objects and close the window.
NOTICE
While driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open) position, your
vehicle may demonstrate a wind buffet
-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
2.5 cm (1 inch) If you experience the
noise with the sunroof open, slightly
reduce the size of the sunroof opening.
CAUTION
Do not install any accessory in the vehi
-
cle that extend into the open window
area. Such an object will impact the
proper function of the Automatic rever
-
sal "jam protection" feature.
NOTICE
If you press the one-touch window but
-
ton for micro adjustment, the glass will
move to a specific location to improve
your convenience.
Window opening and closing
You can open and close windows using
the power window switch.
Type A
To open or close a window, press down
or pull up the front portion of the corre
-
sponding switch to the first detent posi
-
tion (1).
Type B - Auto up/down window
Pressing or pulling up the power window
switch momentarily to the second detent
position (2) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position while the window is in
operation, pull up or press down and
release the switch.
OCL4M034031N
OCL4M034032N

Table of Contents

Related product manuals