Kia K4 2025 - Wipers and Washers

Features of your vehicle
884
Wipers and washers
僅 There is a temporary reflector or flash
ahead (construction area).
僅 The road conditions are poor such as
being wet, iced or covered with snow.
僅 A vehicle suddenly appears from a
curve.
僅 The vehicle is tilted from a flat tire or
is being towed.
僅 Light from a vehicle is not detected
because of exhaust fume, smoke, fog,
snow, etc.
NOTICE
僅 Depending on the instrument cluster
specification or theme, images or col -
ors may be displayed differently.
僅 For more details on the limitations of
the front view camera, refer to "For -
ward Collision-Avoidance Assist (FCA)
(Sensor Fusion) (if equipped)" on page
6-4.
僅 You can check it in the service mes
-
sage of the utility information view of
the cluster display window.
WARNING
僅 High Beam Assist may not turn off
high beams every time. This function
is for your convenience only. It is the
responsibility of the driver to always
check the road conditions and adjust
headlights appropriately, including by
using the manual controls. for your
safety.
僅 It may not operate for 15 seconds
after the vehicle is started, or the front
view camera is initialized or restarted.
僅 If the high beam assistance is not
operated properly, switch the head
-
lights manually.
Wipers and washers
The wipers and washers remove foreign
substances from the windshield and rear
window, helping to maintain visibility.
1 Wiper speed control
僅 MIST – Single wipe
僅 OFF – Off
僅 INT – Intermittent wipe
僅 LO – Low wiper speed
僅 HI – High wiper speed
2 Intermittent control wipe time
adjustment
3 Wash with brief wipes
NOTICE
If there is heavy accumulation of snow
or ice on the windshield, do not drive
and defrost the windshield for about 10
minutes, or until the snow and/or ice is
removed before using the windshield
wipers to ensure proper operation. If you
do not remove the snow and/or ice
before using the wiper and washer, it
may damage the wiper and washer sys
-
tem.
INFORMATION
If you operate the wipers while driving
on snowy roads, the wipers may stop
due to snow buildup on your windshield.
This is normal and not a failure because
it is one of our safety features to prevent
vehicle accidents and wiper damage
from overloading the wiper motor. If the
wipers stop, remove snow accumulated
OCL4M034005N