Driver assistance guide
886
Highway Driving Assist (HDA)
僅 For your safety, please read the
owner's manual before using the
Highway Driving Assist.
僅 Highway Driving Assist will not oper
-
ate when the vehicle is started, or
when the detecting sensors or naviga
-
tion is being initialized.
You can check it in the service message
of the utility information view of the
instrument cluster display window.
Limitations of Highway Driving
Assist
Highway Driving Assist and Highway
Lane Change Assist may not operate
properly, under the following circum
-
stances:
僅 The map information and the actual
road is different because the naviga
-
tion is not updated
僅 The map information and the actual
road is different because of real-time
GPS data or map information error
僅 The infotainment system is over
-
loaded by simultaneously performing
functions such as route search, video
playback, voice recognition, etc.
僅 GPS signals are blocked in areas such
as a tunnel
僅 You veer off course, reset the naviga
-
tion route by changing the destination
(including route change according to
real-time road traffic information) or
cancel the route to the destination
僅 The vehicle enters a service station or
rest area
僅 Android Auto or CarPlay is operating
僅 The navigation cannot detect the cur
-
rent vehicle position (for example, ele
-
vated roads, including overpasses
adjacent to general roads or nearby
parallel roads)
僅 If your vehicle fails to recognize white
single dashed lane lines and road
boundaries
僅 If some lanes are temporarily
restricted
僅 If there are no physical separation
structures, such as a center median, in
the middle of the road
僅 If the lane you intend to change to is a
bus lane or a variable lane
僅 If you have a trailer, carrier, or other
equipment attached
For more details of the front view cam
-
era, front radar, front corner radar and
rear corner radar sensor, refer to "For
-
ward Collision-Avoidance Assist (FCA)
(Sensor Fusion) (if equipped)" on page
6-4.
This device complies with Indus
-
try Canada licence-exempt RSS
standard(s).
Operation is subject to the following
three conditions:
1. This device may not cause interfer
-
ence, and
2. This device must accept any interfer
-
ence, including interference that may
cause undesired operation of the
device.
3. Changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to oper씪ate the
device.
To Next Page
Loading...
