Maintenance
528
Appearance care
Replacing turn signal lamp and
stop lamp (Rear combination
lamp) (Type A) (if equipped)
1
Stop lamp
2
Turn signal lamp
To replace the bulb:
1. Engage the parking brake, shift to P
and turn the ignition OFF.
2. Turn of the rear combination lamp.
3. Open the trunk.
4. Remove the rear combination lamp
assembly from the body of vehicle
using the flat-blade screwdriver.
5. Remove the socket from the assembly
by pressing it in and rotating it coun
-
terclockwise
6. Pull the bulb out of the socket.
7. Insert a new bulb into socket.
8. Push the socket into the assembly
and turn the socket clockwise.
9. Reinstall the assembly to the body of
the vehicle.
Appearance care
Use the information in the following sec
-
tions to keep the exterior and interior of
your vehicle clean.
Exterior care
Use the information in the following sec
-
tions to maintain the exterior of your
vehicle. Keeping the exterior clean is not
only aesthetically pleasing, but also
helps to prolong the life of your vehicle.
If you park the vehicle around a stainless
signboard or windshield building etc.,
the plastic exterior trim (bumper, spoiler,
garnish, lamp, outside mirror etc.) may
be damaged by reflected sunlight from
the external structure. To avoid damag
-
ing the plastic exterior trim, park the
vehicle away from areas where the
reflected light may occur or use a vehi
-
cle cover. (Depending on the vehicle, the
type of exterior trim applied such as the
spoiler, may differ.)
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning and
caution statements that appear on the
label.
Finish maintenance
Washing
To help protect your vehicle's finish from
rust and deterioration, wash it thor
-
oughly and frequently at least once a
month with lukewarm or cold water.
If using your vehicle for off-road driving,
you should wash it after each off-road
To Next Page
Loading...
