19
5
5
Driving your vehicle Dual clutch transmission (DCT)
RELEASE" access hole at the same
time. Then the vehicle will move when
external force is applied.
僅 Always park the vehicle in "P" (Park)
for safety and engage the parking
brake. If left in "N" (Neutral), the vehi
-
cle may move and cause serious dam
-
age and injury.
僅 Before parking in "N" (Neutral) gear,
first make sure the parking ground is
level and flat. Do not park in "N" gear
on any slopes or gradients.
If parked and left in "N", the vehicle
may move and cause serious damage
and injury.
僅 After the ignition switch or ENGINE
START/STOP button has been turned
off, the electronic parking brake can
-
not be disengaged.
僅 For EPB (Electronic Parking Brake)
equipped vehicles with AUTO HOLD
function used while driving, if the igni
-
tion button has been turned "OFF", the
electronic parking brake will be
engaged automatically. Therefore,
AUTO HOLD function should be
turned off before the ignition button is
turned off.
D (Drive)
This is the normal driving position. The
transmission will automatically shift
through a 8 gear sequence, providing
the best fuel economy and power.
For extra power when passing another
vehicle or driving uphill depress the
accelerator pedal further until you feel
the transmission downshift to a lower
gear.
To stop the vehicle during driving,
please press brake pedal fully to prevent
unintended movement.
Manual mode
Whether the vehicle is stationary or in
motion, manual mode can be selected
by pushing the shift lever from the D
(Drive) position into the manual gate. To
return to D (Drive) range operation, push
the shift lever back into the main gate.
Manual mode manages the driving
dynamics by automatically adjusting the
steering effort, and the engine and
transmission control logic for enhanced
driver performance.
In manual mode, moving the shift lever
backwards and forwards will allow you
to select the desired range of gears for
the current driving conditions.
僅 Up (+): Push the lever forward once to
shift up one gear.
僅 Down (-): Pull the lever backwards
once to shift down one gear.
僅 If the driver presses the lever to + (Up)
or - (Down) position, the transmission
may not make the requested gear
change if the next gear is outside of
the allowable engine rpm range.
ODL3059202
To Next Page
Loading...
