27
6
6
Driving your vehicle Dual clutch transmission (DCT) (Dial SBW)
In emergencies, do the following to
move the shift dial to N (Neutral) on a
level ground.
1. Connect the battery cables from
another vehicle or from a another bat
-
tery to the jump-starting terminals
inside the engine compartment. For
more details, refer to "Emergency
starting" on page 7-5.
2. Release the parking brake with the
ENGINE START/STOP button in the
ON position.
3. Shift the gear to the N (Neutral) posi
-
tion. If you want to keep the N position
after the vehicle is off, disconnect the
battery from vehicle or refer to "Stay
in N (Neutral) position when vehicle is
Off" on page 6-26.
僅Always park the vehicle in "P"(Park)
for safety and engage the parking
brake. If left in "N", the vehicle may
move and cause serious damage and
injury.
僅 After the ENGINE START/STOP but
-
ton has been turned off, the electronic
parking brake cannot be disengaged.
僅 For EPB (Electronic Parking Brake)
equipped vehicles with AUTO HOLD
function used while driving, if the igni
-
tion button has been turned "OFF", the
electronic parking brake will be
engaged automatically. Therefore,
AUTO HOLD function should be
turned off before the ignition button is
turned off.
LCD display messages
If a message appears on the LCD dis
-
play, refer to the next section for the
appropriate steps to take.
Shifting conditions not met
A:
Shifting conditions not met. Reduce
speed, then shift
The message appears on the LCD dis
-
play in the following conditions:
僅 When driving speed is too fast to shift
the gear. Decrease the vehicle speed
or slow down before shifting the gear.
Press brake pedal to change gear
A:
Press brake pedal to change gear
The message appears on the LCD dis
-
play, when the brake pedal is not
depressed while shifting the gear.
Depress the brake pedal and then shift
the gear.
Shift to P after stopping
A:
Shift to P after stopping
To Next Page
Loading...
