What to do in an emergency
247
If you have a flat tire (with tire mobility kit)
6. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
7. Make the ENGINE START/STOP but
-
ton position on or ignition switch posi
-
tion on.
8. Switch on the compressor and let it
run for approximately 5 ~ 7 minutes
to fill the sealant up to proper pres
-
sure. (refer to "Tires and wheels" on
page 8-32). The inflation pressure of
the tire after filling is unimportant and
will be checked/corrected later. Be
careful not to overinflate the tire and
stay away from the tire when filling it.
When the tire and wheel are dam
-
aged, do not use Tire Mobility Kit for
your safety.
If the tire pressure is below
26psi(180kPa), do not drive the vehicle.
The tire may cause accident.
9. Switch off the compressor.
10.Detach the sealant filling hoses from
the sealant bottle connector and from
the tire valve. After using, leave the
sealant bottle and the compressor
attached together.
Return the TMK to its storage location in
the vehicle.
Carbon monoxide
Do not leave your vehicle running in a
poorly ventilated area for extended peri
-
ods of time. Carbon monoxide poisoning
and suffocation can occur.
Distributing the sealant
僅 Immediately drive approximately 4 ~
6 miles (7 ~ 10 km or, about 10min) to
evenly distribute the sealant in the
tire.
Do not exceed a speed of 50 mph (80
km/h). If possible, do not fall below a
speed of 12 mph (20 km/h).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road. Call for road side
service or towing.
When you use the Tire Mobility Kit, the
wheel may be stained by sealant. There
-
fore, remove the wheel stained by seal
-
ant and have the vehicle inspected at an
authorized Kia dealer.
To Next Page
Loading...
