APPEARANCE CARE
Exterior care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning and
caution statements that appear on the
label.
Finish maintenance
Washing
To help protect your vehicle’s finish
from
rust and deterioration, wash it
thoroughly and frequently at least once
a month with lukewarm or cold water.
If you use your vehicle for off-road
driving, you should wash it after each
off-road trip. Pay special attention to
the removal of any accumulation of
salt, dirt, mud, and other foreign mate‐
rials. Ensure drain holes in the lower
edges of the doors and rocker panels
are kept clean.
Insects, tar, tree sap, bird droppings, in‐
dustrial pollution and similar deposits
can damage your vehicle’s finish if not
removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits.
A mild soap, safe for use on painted
surfaces, may be used.
After washing, rinse the vehicle thor‐
oughly
with lukewarm or cold water. Do
not allow soap to dry on the finish.
CAUTION
• Do not use strong soap, chemical
deter
gents or hot water, and do
not wash the vehicle in direct sun‐
light or when the body of the vehi‐
cle is warm.
• Be careful when washing the side
windows
of your vehicle. Especial‐
ly, with high-pressure water, wa‐
ter may leak through the windows
and wet the interior.
• To prevent damage to the plastic
parts
and lamps, do not clean with
chemical solvents or strong deter‐
gents.
WARNING
n
W
et brakes
After washing the vehicle, test the
brakes while driving slowly to see if
(Continued)
(Continued)
they have been affected by water. If
braking
performance is impaired, dry
the brakes by applying them lightly
while maintaining a slow forward
speed.
High-pressure washing
• When using high-pressure washers,
make sure to maintain sufficient dis‐
tance from the vehicle.
Insufficient clearance or excessive
pressure can lead to component
damage or water penetration.
• Do not spray the camera, sensors or
its surrounding area directly with a
high pressure washer. Shock applied
from high pressure water may cause
the device to not operate normally.
• Do not bring the nozzle tip close to
boots (rubber or plastic covers) or
connectors as they may be damaged
if they come into contact with high
pressure water.
8-77
8
Maintenance
To Next Page
Loading...
