3. Remove the engine oil filter with an oil filter
wrench.
4. Use a clean rag to clean the oil filter mounting
surface on the engine.
5. Apply a small amount of engine oil to the new oil
filter O-ring seal.
6. Install the oil filter and tighten it. (Refer to
the oil filter caution label for tightening
instructions.)
7. Install a new washer on the drain plug.
8. Replace the drain plug after the oil has
thoroughly drained. Torque the plug to 22lb•ft
(30N•m)
9. Refill the engine with new oil to the F mark on
the dipstick. Do not overfill.
10. Replace the oil filler cap securely.
11. Start the engine and inspect around the oil filter
seal for leaks. Stop the engine.
12. Check the oil level and fill to the F mark as
necessary.
Maintenance
7-18
✽✽
NOTICE
Do not allow the oil filter gasket to remain on
the oil filter mounting surface. This will cause
oil leakage and engine damage. Remove the
old gasket completely so that a new gasket
may be properly seated.
To Next Page
Loading...
