Changing the Automatic Transaxle Fluid
1. Raise and suitably support the vehicle.
2. Remove the drain plug located at the bottom
center front of the transaxle pan.
3. After the oil has drained, completely install a
new washer on the plug, reinstall the drain plug,
and tighten to 22 lb•ft (30 N•m).
4. Lower the vehicle.
5. Remove the Automatic Transaxle dipstick
located near the center of the engine
compartment bulkhead and, using a funnel, add
approximately 2 US quarts (2 liters) of automatic
transaxle fluid
Maintenance
7-30
WARNING - Lifting Your
Vehicle
If you raise your vehicle, always ensure
that it is supported at all four jacking or lift
points for the vehicle. Do not use jacks
meant for tire changes. Use only lift
equipment specifically recommended for
doing maintenance work under the vehicle.
Place the vehicle and lift equipment on a
hard, level surface capable of supporting
the full weight of the vehicle without
moving or deforming. If the support is not
stable, the vehicle could fall and cause
serious or fatal injuries. Follow the
instructions with the lift device.
To Next Page
Loading...
