6. Check the fluid level. If necessary, add a small
amount of fluid and check the level again.
Continue this process until the level reads
between the 75°C notches.
7. Replace the dipstick and properly dispose of the
used transaxle fluid.
7-31
✽✽
NOTICE
Do NOT overfill the automatic transaxle
reservoir. Doing so can cause a seal “blow
out,” loss of fluid, and damage to the transaxle.
If you overfill the reservoir, you must drain the
excess prior to driving the vehicle. The
transaxle will hold 2.7 qts. (2.5L) when
completely empty. However, it is likely that
there will be fluid left in the transaxle after
draining, especially if the front of the vehicle
was raised to remove the drain plug.
To Next Page
Loading...
