Kia sedona 2015 - Homelink with Auto-Dimming Rearview Mirror

SEDONA FEATURES & FUNCTIONS GUIDE
38
*IF EQUIPPED
How to Sync Transmitter with HomeLink
®
*
Erasing programmed buttons:
If programming for the first time, begin with Step 1 (repeating this step will
delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the left
A
and center
D
buttons simultaneously until the
indicator light
C
begins to flash (to reprogram buttons, skip this step)
2. Press and hold the desired button
A B D
and hold the button on the
transmitter while it is approximately 1 to 3 inches away from the mirror. The
HomeLink
®
Indicator light
C
will flash rapidly once the frequency signal has
been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit.
Press and release the button and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
®
button up to three times
Press and hold the left
A
and center
D
buttons simultaneously for
approximately 20 seconds, and then release both buttons within 30 seconds.
Operating HomeLink
®
:
Press one of the programmed HomeLink
®
buttons.
REMINDER: Mirror indicator light
C
will illuminate when automatic dimming is ON.
If your garage door opener was manufactured in 2011 or later, and you’re unable to program
your vehicle’s HomeLink
®
system, you may need to purchase a HomeLink Repeater Kit. For more
information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink
®
/ Auto-Dimming Rearview Mirror* is designed to
reduce glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters into one location.
• To turn automatic dimming ON, press button
F
• To turn automatic dimming OFF, press button
G
HomeLink
®
with Auto-Dimming
Rearview Mirror*
A
HomeLink
®
button
B
HomeLink
®
button
C
Indicator light
D
HomeLink
®
button
E
Glare detection sensor
F
Automatic dimming ON
G
Automatic dimming OFF
•
• You can reprogram a single HomeLink
®
button by repeating Step 2
• Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
A B C D E F G
OTHER KEY FEATURES