Features of your vehicle
744
Mirrors
僅 Or, call HomeLink customer support
at
1-800-355-3515
(Please have the vehicle make/model
AND the opener device make/model
readily available.)
1) Programming Preparation
1. When programming a garage door
opener, it is advised to park the vehi
-
cle outside of the garage.
2. It is recommended that a new battery
be placed in the hand-held transmit
-
ter of the device being programmed
to HomeLink for quicker training and
accurate transmission of the radio-
frequency signal.
3. Place the ignition switch or ENGINE
START/STOP button to the ACC
(Accessory) position for program
-
ming of HomeLink.
2) Programming a New Home
-
Link씾 Button
1. Press and release the HomeLink but
-
ton (1), (2) or (3), you would like to
program. The HomeLink indicator
light (7) will flash orange slowly (if not,
perform the steps of "Erasing Home
-
Link Buttons" section, and start over).
2. Position the garage door opener
remote 2 - 8 cm (1 - 3 inches) away
from the HomeLink buttons.
3. While the HomeLink indicator light (7)
is flashing orange, press and hold the
hand-held remote button. Continue
pressing the hand-held remote button
until the HomeLink indicator light (7)
light changes from orange to green.
You may now release the hand-held
remote button.
4. Wait until your garage door comes to
a complete stop, regardless of posi
-
tion, before proceeding to the next
steps.
5. Press and release the HomeLink but
-
ton you are programming and
observe the indicator light.
To Next Page
Loading...
