49
3
3
Safety features of your vehicle Child Restraint System (CRS)
5. Remove as much slack from the belt
as possible by pushing down on the
CRS while feeding the shoulder belt
back into the retractor.
6. Push and pull on the CRS to confirm
that the seat belt is holding it firmly in
place. If it is not, release the seat belt
and repeat steps 2 through 6.
7. Double check that the retractor is in
the "automatic locking" mode by
attempting to pull more of the seat
belt out of the retractor. If you cannot,
the retractor is in the "automatic lock
-
ing" mode.
If your CRS manufacturer instructs or
recommends you to use a tether anchor
with the lap/shoulder belt, refer to
"Securing a child restraint seat with
"Tether Anchor" system" on page 3-46
for more information.
When the seat belt is allowed to retract
to its fully stowed position, the retractor
will automatically switch from the "auto
-
matic locking" mode to the emergency
lock mode for normal adult usage.
Auto lock mode
Set the retractor to Automatic Lock
mode when installing any Child Restraint
System. If the retractor is not in the auto
-
matic locking mode, the child restraint
can move when your vehicle turns or
stops suddenly. A child can be seriously
injured or killed if the child restraint is
not properly anchored in the car.
To remove the child restraint, press the
release button on the buckle and then
pull the lap/shoulder belt out of the
restraint and allow the seat belt to
retract fully.
To Next Page
Loading...
