13
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS. *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
A
C
B
Headlight position
Parking light position
AUTO
Auto Light* / LBA-D* / HBA*
OFF
OFF position
It may be helpful to pull/push bottom of Steering
Wheel towards/away from you to adjust desired
distance prior to adjusting the angle.
QUICK TIP
REMINDERS:
• HBA will operate when vehicle speed exceeds 25 mph
• If the lever is pushed away from you while HBA is operational, HBA will turn off and the high beams will be on continuously.
If the lever is pulled toward you while HBA is operational, HBA will turn off
• If the light switch is switched to the headlight position, HBA will turn off and low beams will be on continuously
• When the LBA-D indicator illuminates on the instrument cluster, the LBA-D is not working properly. See authorized Kia dealer
for service
Tilt/Telescoping Steering Wheel
†25
To adjust the Steering Wheel, press the Lock-
Release Lever
A
down and adjust
B
to the
desired angle and
C
distance.
When finished, pull the Lock-Release Lever
A
up to lock Steering Wheel in place.
Headlights & High Beams
To operate:
• Rotate switch to change
the Headlight function
• Push lever to turn High Beams ON
• Pull lever to flash Headlights /
High Beams
AUTO Light function* — When the light switch is in the AUTO Light position, the tail lights and
headlights will turn ON/OFF automatically depending on the amount of light outside the vehicle.
Low Beam Assist - Dynamic (LBA-D)* — The Low Beam Assist-Dynamic is designed to help
improve visibility during nighttime driving by aiming the low beam headlights in the direction the
vehicle is moving. LBA-D controls the aiming direction based on steering angle and speed. When the
headlight switch is in the AUTO Light position, the LBA-D will activate.
High Beam Assist (HBA)* — High Beam Assist is designed to automatically adjust the headlight
range by switching between high and low beams based on light from other vehicles and road
conditions.
To enable HBA, toggle the light switch to the AUTO Light position and turn on the high beams by
pushing the lever away from you. The High Beam Assist indicator
will illuminate.
STEERING WHEEL CONTROLS
To Next Page
Loading...
