Kia Sedona - Smart Cruise Control (SCC) with Stop & Go

SEDONA FEATURES & FUNCTIONS GUIDE
18
*IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
60
60
60
60
SCC canceled
E G
(Type B; buttons located on right side of
Steering Wheel)
A
B
D F
REMINDER: Above are approximate distances based on 56 mph vehicle
speed. The SCC vehicle-to-vehicle distance increments are based on
vehicle speed.
172ft 130ft
82ft
106ft
C
Smart Cruise Control (SCC) with Stop & Go*
†6
The Smart Cruise Control (SCC) with Stop & Go system is designed to maintain a predetermined
distance from vehicles detected ahead by automatically adjusting the driving speed as needed.
When traffic is encountered, the vehicle will be slowed to maintain a set distance behind traffic
without depressing the accelerator or brake pedal.
To set/adjust SCC speed:
• Press the CRUISE button
A
to turn system ON. The CRUISE indicator will illuminate on the
instrument cluster
• Accelerate/decelerate to the desired speed
• Press (SET-) button
B
down to set speed. The SET indicator light will illuminate. The set
speed and vehicle-to-vehicle distance will illuminate on the LCD screen
• Press button
B
up or down to adjust the set speed
To set the vehicle-to-vehicle distance
C
: Press the SCC button
D
on the steering wheel.
The image on the LCD screen
E
will change when scrolling through the settings.
To cancel SCC operation: Press the CANCEL button
F
or press the brake pedal. The LCD
screen will display a message that the SCC operation is cancelled
G
.
To turn SCC system OFF: Press the CRUISE button
A
. The CRUISE indicator on the
instrument cluster will turn OFF.
REMINDERS:
• Cruise Control button must be ON in order to turn SCC ON/OFF
• The SCC system is operating when driving above the speed of 6 mph
• SCC is activated when ignition is turned on. Speed will need to be reset when ignition is cycled on
• The SCC system remains ON when ignition is cycled. The speed setting will need to be reset
when ignition is cycled
• SCC is also canceled when the driver’s door is opened, gear shift is changed out of D (Drive),
EPB is activated and various other conditions. See Owner’s Manual for other conditions
• In standard Cruise Control, the driver needs to manually assess the distance from other vehicles
as the system will not apply brakes to slow down automatically
• If the SCC system is left on, it can be activated inadvertently. Keep the system off when not in
use to avoid setting a speed that the driver is not aware of
• When following a vehicle, the system will automatically adjust your cruise speed based on the
vehicle detected in front
To change the Cruise Control mode from SCC to standard Cruise Control, press and hold
button
D
. Repeat to switch modes again (The SCC system must not be activated to
change modes).
For the SCC system to operate:
• When no vehicle is in front, you must be travelling at a minimum speed of 20 mph
• When following a vehicle, you must be traveling at a minimum speed of 6 mph
When following a vehicle, the system will automatically adjust your cruise speed based
on the vehicle in front. It will even bring the vehicle to a complete stop if necessary. If
the vehicle remains at a standstill for more than 3 seconds, the system will disable.
QUICK TIPS
The SCC system is a supplemental system and is not a substitute for safe driving. It is the
responsibility of the driver to always check the speed and distance to the vehicle ahead.
Smart Cruise Control
(SCC) with Stop & Go
Video
QR CODE
www.youtube.com/KiaFeatureVideos
STEERING WHEEL CONTROLS