15
4
4
Features of your vehicle Theft-alarm system
Theft-alarm system (if
equipped)
Theft-alarm system is designed to
provide protection from unautho
rized entry into the vehicle.
Vehicles equipped with a theft alarm
system will have a label attached to
the vehicle with the following words:
1. WARNING
2. SECURITY SYSTEM
This system is operated in three
stages:
䳜 Armed stage
䳜 Theft-alarm stage
䳜 Disarmed stage
If triggered, the system provides an
audible alarm with blinking of the
hazard warning lights.
Armed stage
Theft Alarm System goes to Armed
stage after 30 seconds from the
doors are locked by switch on a Out
side Door Handle/by a lock button
on transmitter.
Using the smart key
Park the vehicle and stop the
engine. Arm the system as
described below.
1. Turn off the engine.
2. Make sure that all doors (and tail
gate) and the engine hood are
closed and latched.
3. Do one of the following:
䳜 Lock the doors by pressing the
button of the front outside
door handle with the smart key
in your possession.
After completion of the steps
above, the hazard warning
lights operate once to indicate
that the system is armed.
If any door remains open, the
doors won't lock and the chime
will sound for 3 seconds. Close
the door and try again to lock
the doors.
If tailgate or engine hood
remains open, the hazard
warning lights won't operate
and theft-alarm will not arm.
After this, if the tailgate and
engine hood are closed, the
hazard warning lights will blink
once.
䳜 Lock the doors by pressing the
lock button on the smart key.
After completion of the steps
above, the hazard warning
lights will operate once to indi
cate that the system is armed.
To Next Page
Loading...
