9
6
6
Driving your vehicle Key positions
䳜 If the engine does not start within
10 seconds after the preheating is
completed, turn the ignition key
once more to the LOCK position
for 10 seconds, and then to the
ON position, in order to preheat
again.
Starting and stopping the engine
for turbocharger intercooler
1. Do not race or accelerate the
engine immediately after start
ing.
If the engine is cold, idle for sev
eral seconds before sufficient
lubrication is ensured in the tur
bocharger unit.
2. After high speed or extended
driving, requiring a heavy engine
load, idle the engine about 1 min
ute before turning it off.
This idle time will allow the turbo
charger to cool prior to shutting
the engine off.
Do not turn the engine off immedi
ately after it has been subjected to
a heavy load. Doing so may cause
severe damage to the engine or tur
bocharger unit.
If the engine stalls while you are in
motion, do not attempt to move the
shift lever to the P (Park) position. If
traffic and road conditions permit,
you may put the shift lever in the N
(Neutral) position while the vehicle is
still moving and turn the ignition
switch to the START position in an
attempt to restart the engine.
䳜 Do not engage the starter for
more than 10 seconds. If the
engine stalls or fails to start, wait
5 to 10 seconds before re-engag
ing the starter. Improper use of
the starter may damage it.
䳜 Do not turn the ignition switch to
the START position with the
engine running. It may damage
the starter.
To Next Page
Loading...
