121
4
4
Features of your vehicle Wipers and washers
Operating windscreen washers
Type A
Type B
Type C
1. Move the wiper speed control switch
to In OFF position.
2. Pull the lever gently toward you to
spray washer fluid on the windscreen
and to run the wipers 1-3 cycles. Use
this function when the windscreen is
dirty. The spray and wiper operation
will continue until you release the
lever.
If the washer does not work, check the
washer fluid level. If the fluid level is not
sufficient, you will need to add appropri
-
ate non-abrasive windscreen washer
fluid to the washer reservoir.
The reservoir filler neck is located in the
front of the engine compartment on the
driver side.
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
Do not use the washer in freezing tem
-
peratures without first warming the
windscreen with the defrosters; the
washer solution could freeze on the
windscreen and obscure your vision.
僅 To prevent possible damage to the
wipers or windscreen, do not operate
the wipers when the windscreen is
dry.
僅 To prevent damage to the wiper
blades, do not use petrol, kerosene,
paint thinner, or other solvents on or
near them.
僅 To prevent damage to the wiper arms
and other components, do not
attempt to move the wipers manually.
To Next Page
Loading...
