Kia seltos 2023 - 僅 Automatic Air Ventilation

149
4
4
Features of your vehicle Windscreen defrosting and defogging
Step 1: Outside air position
Step 2: Blowing air flow toward the
windscreen
Step 3: Increasing air flow toward the
windscreen
Step 4: Operating the air conditioning.
(For except european region)
Step 1: Operating the air conditioning.
Step 2: Outside air position
Step 3: Blowing air flow toward the
windscreen
Step 4: Increasing air flow toward the
windscreen
(Step could be changed according to the
out side temperature)
To cancel or reset the Auto
Defogging System
Press the front windscreen defroster
button for 3 seconds when the ENGINE
START/STOP button is in the ON posi -
tion.
When the ADS system is cancelled, Indi -
cator on the button will blink 3 times per
0.5 sec and the position “ADS OFF” will
be displayed on the climate control
information screen.
When the ADS system is reset, Indicator
on the button will blink 6 times per 0.25
sec and the position “ADS OFF” will be
disappeared on the climate control infor -
mation screen.
You can set or release the Auto Defog -
ging System on the Climate Information
selection screen.
Auto Defog System is activated when
you select ‘Settings → Vehicle → Climate
→ Defog/Defrost options → Auto defog’
from the Settings in the Infotainment
System screen.
If the battery is discharged or detached,
the auto defogging system will be reset.
Adjust the feature accordingly.
CAUTION
僅 Pressing one of Air intake recircula -
tion, A/C OFF, Wind Direction Mode
selection Buttons will deactivate the
Auto Defogging System. To secure a
driver’s vision, never push air recircu -
lation, A/C OFF, Wind Direction But -
tons whilst the Auto Defogging
System is running.
僅 Do not forcibly remove the sensor
cover on the top of windscreen glass
on the driver's side in the car. Remov -
ing the cover can damage the sensor.
Automatic Air Ventilation
When operating heater and air condi -
tioner for the vehicle ventilation, if you
maintain the Recirculation mode for 30
minutes or over at low temperature, it
automatically changes to Fresh mode.
Automatic Air Ventilation control
procedure
When set up or release the automatic air
ventilation function, select the Mode
Selection button at heater or air con -
ditioner on. And press the Air Intake
Control button for 5 times or over within
3seconds together within 3 seconds
together within 3 seconds together with
pressing the Air conditioning button.
When release the automatic ventilation
function, the Recirculation mode indica -
tor will blink 3 times at 0.5 second inter -
vals and air direction, air volume,
Recirculation/Fresh mode, and air condi -
tioner is automatically controlled.
When it set the automatic ventilation
function, the Recirculation mode indica
-
tor will blink 6 times at 0.25 seconds