7
5
5
Driving your vehicle Key positions
START (4)
Turn the ignition switch to the START
position to start the engine. The engine
will crank until you release the key; then
it returns to the ON position. The brake
warning light can be checked in this
position.
Ignition switch
僅 Never turn the ignition switch to LOCK
or ACC whilst the vehicle is moving.
This would result in loss of directional
control and braking function, which
could cause an accident.
僅 The anti-theft steering column lock is
not a substitute for the parking brake.
Before leaving the driver's seat,
always make sure the shift lever is
engaged in 1st gear for the manual
transmission, set the parking brake
fully and shut the engine off. Unex
-
pected and sudden vehicle movement
may occur if these precautions are
not taken.
僅 Never reach for the ignition switch, or
any other controls through the steer
-
ing wheel whilst the vehicle is in
motion. The presence of your hand or
arm in this area could cause a loss of
vehicle control, an accident and seri
-
ous bodily injury or death.
僅 Do not place any movable objects
around the driver's seat as they may
move whilst driving, interfere with the
driver and lead to an accident.
Starting the engine
僅 Always wear appropriate shoes when
operating your vehicle. Unsuitable
shoes (high heels, ski boots, etc.) may
interfere with your ability to use the
brake and accelerator pedal, and the
clutch. (if equipped)
僅 Do not start the vehicle with the accel
-
erator pedal depressed. The vehicle
can move and lead to an accident.
僅 Wait until the engine rpm is normal.
The vehicle may suddenly move if the
brake pedal is released when the rpm
is high.
Manual Transmission
1. Make sure the parking brake is
applied.
2. Depress the clutch pedal fully and
shift the transmission into Neutral.
Keep the clutch pedal and brake
pedal depressed whilst turning the
ignition switch to the start position.
3. Turn the ignition switch to START and
hold it there until the engine starts (a
maximum of 10 seconds), then
release the key.
It should be started
without depress
-
ing the accelerator pedal.
4. Do not wait for the engine to warm up
whilst the vehicle remains stationary.
Start driving at moderate engine
speeds. (Steep accelerating and
decelerating should be avoided.)
Automatic Transmission/Intelli
-
gent Variable Transmission
1. Make sure the parking brake is
applied.
2. Place the transmission shift lever in P
(Park). Depress the brake pedal fully.
You can also start the engine when
the shift lever is in the N (Neutral)
position.
3. Turn the ignition switch to START and
hold it there until the engine starts (a