Safety features of your vehicle
143
Seat
not be properly secured and may hit the
front seat occupants in a collision.
Cargo loading
Make sure the engine is off, the trans
-
mission is in P (Park) or the manual
transmission is in R (Reverse) or 1st, and
the parking brake is securely applied
whenever loading or unloading cargo.
Failure to take these steps may allow the
vehicle to move if the shift lever is inad
-
vertently moved to another position.
To unfold the rear seat
Uprighting seat
When you return the seatback to its
upright position, hold the seatback and
return it slowly. If the seatback is
returned without holding it, the back of
the seat could spring forward resulting
in injury caused by being struck by the
seatback.
1. Lift and pull the seatback backward
and be careful not to be located the
seat belt between the rear seat and
vehicle body. Pull the seatback firmly
until it clicks into place.
2. Make sure the seatback is locked in
place. When you return the seatback
to its upright position, always be sure
it has locked into position by pushing
on the top of the seatback.
If you can not see the red line at the
bottom of folding lever, it means the
seatback is locked completely.
3. Return the rear seat belt to the proper
position.
4. When the seatback is completely
installed, check the seatback folding
lever again.
5. If you want to tilt the rear seatback a
bit more, whilst pulling on the seat
-
back folding lever and push the top of
the rear seatback towards the rear.
Then release the lever and make sure
that the rear seat is firmly locked.
僅 Avoid excessive force when unfolding
rear seat back.
僅 Unfolding the seat with excessive
force may lead to lock seat back in
2nd step. This is natural phenomenon
and adjust to the desired position if
necessary.
To Next Page
Loading...
