*IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
12
SELTOS FEATURES & FUNCTIONS GUIDE
ADAS
ADVANCED DRIVER ASSISTANCE SYSTEMS (ADAS)
Rear Cross-Traffic Collision Avoidance Assist (RCCA)*
†6
REMINDERS:
• The RCCA feature can be turned
OFF/ON in User Settings, under
Driver Assistance, Parking
Safety
• When vehicle power is cycled,
RCCA will remain in the previous
state
• When a vehicle is approaching
within the sensing range, and
traveling faster than 3 mph,
the RCCA system will show a
warning
• The RCCA systems is a
supplemental system. Do not
solely rely on this system and
always pay attention to the road
and its conditions
Rear Cross-Traffic Collision-Avoidance Assist (RCCA) is designed to warn the driver, under certain
conditions, may activate the Electronic Stability Control (ESC) and temporarily apply braking if it
detects cross traffic approaching the vehicle, when vehicle is in reverse.
Initially, RCCA provides Rear Cross-Traffic Collision Warning (RCCW) when the system sensors
detect approaching vehicles or pedestrians from the rear left or rear right side of the vehicle
A
.
RCCA will sound a warning, the warning indicators on the outside rearview mirror will illuminate
and a message will appear on the Instrument Cluster LCD
B
. If RCCA detects that the collision
risk has increased, the system automatically applies the brakes to reduce your speed, potentially
helping to minimize the effects of a possible collision.
RCCA is designed to operate under the following conditions:
• When the gear shift is in Reverse
• When the vehicle is moving slower than 6 mph
RCCA User Settings:
• To go to the User Settings menu in the Instrument Cluster, press the Mode button
C
on the Steering Wheel when the vehicle is at a standstill, gear shift in Park and with the
ignition on or the Engine Start/Stop button* in the ON position, and select User Settings
• To turn RCCA on when in User Settings , press the Move (OK) button
D
up/down, select
Driver Assistance, Parking Safety, Rear Cross-Traffic Safety and then press OK
D
• To set the initial warning activation time, go to User Settings , press the Move (OK) button
D
up/down, then go to Driver Assistance, Warning Time and press the OK button
D
• There are two settings:
– Early/Normal: Maximizes the amount of distance between the
vehicles before the initial warning occurs
– Late: Reduces the amount of distance between the vehicles
before the initial warning occurs
• Some models access settings through the Vehicle Settings in the
audio head unit. Press the Setup hard key on the audio head unit,
then VEHICLE on the screen to enter Vehicle Settings
Refer to section 4 in the Owner’s
Manual for more information.
RCCA Warning Volume can be adjusted in the User Settings
in the Instrument Cluster or the Vehicle Settings on the audio
head unit. Go to Driver Assistance, then Warning Volume
QUICK TIP
A
B
Refer to the inside front cover for
more information on QR codes.
www.youtube.com/KiaFeatureVideos
QR CODES
Rear Cross-Traffic
Collision Avoidance
Assist (RCCA) Video
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
MODE
OK
RES
SET
+
–
CRUISE
CANCEL
CANCEL
OK
RES
SET
+
–
CRUISE
CANCEL
OK
MODE
C
D
(Type A; Controls located on right side of
Steering Wheel)
To Next Page
Loading...
