Kia SELTOS - Drivers Panel; Instrument Cluster Control; Electronic Stability Control (ESC); Hill-Start Assist Control (HAC)

*IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
18
SELTOS FEATURES & FUNCTIONS GUIDE
Hill-Start Assist Control (HAC)
†8
HAC is designed to help prevent the vehicle from rolling backward when
accelerating from a stop while on a steep incline.
The HAC automatically activates whether the ESC is OFF or ON but does
NOT activate when the ESC has malfunctioned.
REMINDERS:
• The HAC does not operate when the gear shift is in the P (Park) or the N (Neutral) position
• HAC does not replace the need to apply brakes while the vehicle is stopped on an incline
• In the event of HAC system malfunction, see an Authorized Kia Dealer for service
•
• When HAC is active (e.g., during initial acceleration from a stop on an incline),
you may notice that the brakes will momentarily remain engaged after you
depress the accelerator – this is normal operation
• HAC provides a two-second delay before the vehicle may start rolling backward
QUICK TIPS
OFF
(Buttons located on left of Steering Wheel)
Instrument Cluster Control
With parking lights/headlights ON, toggle switch
A
up (+)
or down (-) to adjust the brightness of the instrument panel
illumination.
Electronic Stability Control (ESC)
†8
ESC is designed to help stabilize the vehicle during certain
cornering maneuvers. It is a good idea to keep the ESC
turned ON for daily driving whenever possible.
Press the ESC OFF button
B
to turn ESC OFF.
See section 5 in the Owner’s Manual for more information.
See section 4 in the Owner’s Manual for more information.
See section 5 in the Owner’s Manual for more information.
REMINDERS:
• ESC is turned ON by default at vehicle startup. When
ignition is cycled, ESC will turn ON again
• The ESC Indicator Light in the instrument cluster will
illuminate whenever the ESC is in operation
A
B
DRIVER'S PANEL
DRIVER’S
PANEL