67
8
8
Maintenance Fuses
4. Push in a new fuse of the same
rating, and make sure it fits
tightly in the clips. If it fits loosely,
we recommend that you consult a
professional workshop. Kia rec
-
ommends to visit an authorised
Kia dealer/service partner.
After checking the fuse panel in the
engine compartment, securely
install the fuse panel cover through
the audible clicking sound.
If not, electrical failures may occur
from water contact.
Main fuse (Multi fuse)
If the multi fuse is blown, it must be
removed as follows:
1. Turn the ignition switch and all
other switches off.
2. Disconnect the negative battery
cable.
3. Remove the nuts shown in the
picture above.
4. Replace the fuse with a new one
of the same rating.
5. Reverse these steps to reinstall
the multi fuse.
If the multi fuse is blown, consult a
professional workshop. Kia recom
-
mends to consult an authorised Kia
dealer/service partner.
Driver's side fuse panel
Not all fuse panel descriptions in this
manual may be applicable to your
vehicle. It is accurate at the time of
printing. When you inspect the fuse
panel in your vehicle, refer to the
fuse panel label on the inside of the
fuse cover. This diagram will provide
you with the specific information
for your vehicles.
To Next Page
Loading...
