Kia SELTOS - Replacing Front Fog Lamp (Bulb Type) Bulb

83
8
8
Maintenance Light bulbs
Replacing position lamp (auxiliary)
(LED type) (if equipped)
If the auxiliary lamp LED (1) does
not operate, we recommend that
the system be checked by a profes
-
sional workshop. Kia recommends to
visit an authorised Kia dealer/ser
-
vice partner.
The LED lamps cannot be replaced
as a single component because it is
an integrated unit. The LED lamps
have to be replaced with the unit.
A skilled technician should check or
repair the auxiliary lamp (LED), for it
may damage related parts of the
vehicle.
Replacing front fog lamp (bulb
type) bulb (if equipped)
1. Disconnect the negative (-) bat
-
tery terminal.
2. Remove the engine under cover.
3. Disconnect the front fog lamp
connector.
4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counter-clockwise until the tabs
on the bulb align with the slots in
the socket. Pull the bulb out of
the socket.
6. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assem
-
bly and turn the socket clockwise.
OSP2I079065
OSP2079040