Kia SELTOS - Page 66

Driving your vehicle
606
Brake system
䳜 Have the ignition switch or
ENGINE START/STOP button in
the ON position.
䳜 Depress the brake pedal.
䳜 Make sure the brake warning light
goes off.
To release EPB automatically
(manual transmission):
1. Close the driver's door, engine
bonnet and tailgate.
2. Fasten the driver's seat belt.
3. Start the engine.
4. Depress the clutch pedal with the
gear engaged.
5. Depress the accelerator pedal
whilst releasing the clutch pedal.
NOTICE
Manual transmission
A vehicle towing a trailer on a hill or
on an incline may slightly roll back
-
wards when starting the vehicle. To
prevent the situation follow the
below instructions.
1. Depress the clutch pedal and
select a gear.
2. Keep pulling up the EPB switch.
3. Depress the accelerator pedal and
slowly release the clutch pedal.
4. If the vehicle starts off with
enough driving power release the
EPB switch.
Do not follow the above procedure
when driving on a flat level ground.
The vehicle may suddenly move for
-
ward.
To release EPB automatically
(automatic transmission):
1. Close the driver's door, engine
bonnet and tailgate.
2. Fasten the driver's seat belt.
3. Start the engine.
4. If the shift lever is in P (Park),
depress the brake pedal and shift
out of P (Park) to R (Rear) or D
(Drive), the EPB is released auto
-
matically. Make sure the brake
warning light goes off.
5. If the shift lever is in N (Neutral),
depress the brake pedal and shift
out of N (Neutral) to R (Rear) or D
(Drive), the EPB is released auto
-
matically. Make sure the brake
warning light goes off.
䳜 If you try to drive off depress
-
ing the accelerator pedal with
the EPB applied, but doesn't
release automatically, a warn
-
ing will sound once and a mes
-
sage will appear.
䳜 If the driver's seat belt is not
fastened, driver䳓s door is
opened, the engine bonnet is
opened in D or the tailgate is
OSP2059156E