17
5
5
Driving your vehicle Intelligent Manual transmission
僅 Exercise extreme caution when driv
-
ing on a slippery surface. Be espe
-
cially careful when braking,
accelerating or shifting gears. On a
slippery surface, an abrupt change in
vehicle speed can cause the drive
wheels to lose traction and the vehicle
to go out of control.
僅 Always buckle-up! In a collision, an
unbelted occupant is significantly
more likely to be seriously injured or
killed than a properly belted occu
-
pant.
僅 Avoid high speeds when cornering or
turning.
僅 Do not make quick steering wheel
movements, such as sharp lane
changes or fast, sharp turns.
僅 The risk of rollover is greatly
increased if you lose control of your
vehicle at highway speeds.
僅 Loss of control often occurs if two or
more wheels drop off the roadway
and the driver oversteers to reenter
the roadway.
僅 In the event your vehicle leaves the
roadway, do not steer sharply.
Instead, slow down before pulling
back into the travel lanes.
僅 Never exceed posted speed limits.
Intelligent Manual transmis
-
sion (if equipped)
Intelligent Manual Transmission (iMT)
system use E-Clutch (Electronic Clutch)
technology. Using the E-Clutch, the vehi
-
cle can cut engine drive off without
pressing the clutch pedal by driver. The
E-Clutch is controlled by an actuator that
assists the driver in changing gear.
Intelligent Manual Transmission (iMT)
technology improves driving conve
-
nience better than conventional Manual
Transmission. There is NO CLUTCH
PEDAL. The clutch is operated automati
-
cally, whilst shifting gear.
When the driver steps on the accelerator
and tries to shift the gear, there could be
a sense of obstruction compared to
Manual Transmission.
To start engine, press the brake pedal
and the shift lever at neutral position
The driver can operate the vehicle on
the flat ground when the gear is in first
or second but the following warning
message appears if the driver tries to
operate when the gear is put in above
third.
A:
Please shift down
It is possible to drive on a slope with the
gear is in first but the following warning
message appears when the driver oper
-
ates whilst the gear is in above second.
To Next Page
Loading...
