59
8
8
Maintenance Light bulbs
僅 If a bulb becomes damaged or
cracked, replace it immediately and
carefully dispose of it.
僅 Wear eye protection when changing a
bulb. Allow the bulb to cool down
before handling it.
Replacing headlamp (low/high)/
turn signal lamp/position lamp
(bulb type) (headlamp type A)
1. Headlamp (low)
2. Headlamp (high)
3. Turn signal lamp
To prepare replacing the lamp bulb:
1. Open the bonnet.
To replace the headlamp (low/high)
bulb:
1. Remove the front bumper.
2. Remove the headlight from vehicle by
unscrewing the 2 bolts on top of the
headlight.
3. Remove the headlight bulb cover by
turning it counterclockwise.
4. Disconnect the headlight bulb socket-
connector.
5. Unsnap the headlight bulb retaining
wire by depressing the end and push
-
ing it upward.
6. Remove the bulb from the headlight
assembly.
7. Install a new headlight bulb and snap
the headlight bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
8. Connect the headlight bulb socket
connector.
9. Install the headlight bulb cover by
turning it clockwise.
To replace the turn signal lamp, position
bulb:
1. Remove the socket from the assembly
by turning the socket counterclock
-
wise until the tabs on the socket align
with the slots on the assembly.
2. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
3. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
4. Push the socket into the assembly
and turn the socket clockwise.
Replacing headlamp (low/high)/
turn signal lamp/position lamp/
daytime running lamp bulb (LED
type) (headlamp type B)
If the headlamp (low) (1), headlamp
(high) (2), turn signal lamp/position
lamp/daytime running lamp LED (3)
does not operate, we recommend that
the system be checked by a professional
workshop. Kia recommends to visit an
authorised Kia dealer/service partner.
The LED lamps cannot be replaced as a
single component because it is an inte
-
grated unit. The LED lamps have to be
replaced with the unit.
A skilled technician should check or
repair the position lamp/daytime run
-
To Next Page
Loading...
