81
8
8
Maintenance Emission control system
2. Turn on the engine
3. Warm up the engine and check
engine temperature gauge at the mid
-
dle position
4. Turn on the air conditioner and set the
blower to the maximum.
5. Turn on the high beam.
6. Operate the rear defog function.
7. Hold the OK button on the LCD warn
-
ing message page.
A:
Filter regeneration completed.
Restart engine
8. Turn off and turn on the engine again.
Not Operating Condition
A:
Self-regenerating conditions not
met. See owner’s manual
Under below condition, Diesel Catalyst
regeneration process may be inter
-
rupted. (Engine RPM drops to idle state)
僅 Engine overheat or insufficient warm-
up
僅 Shift lever change to D or R state
僅 Acceleration pedal is pressed
僅 Movement of Vehicle (Vehicle speed
over 0)
Service Check
If the DPF indicator change from
appears to blink or Engine Check Lamp
(MIL) appears with DPF indicator in spite
of the procedure, please visit an autho
-
rised Kia dealer/service partner and then
check the Diesel Catalyst and engine
system including oil level inspection.
Please note that the vehicle acceleration
is limited to protect engine system when
DPF indicator blinks or Engine Check
Lamp (MIL) appears.
Operating Self Regeneration
Mode
A:
Regenerating filter...
If the self regeneration mode starts, the
message "Filter regenerating⋯" and the
remaining time appears. It takes around
30~60 minutes.
Self Regeneration Mode Fail
A:
Self-regeneration cancelled
The regeneration operation could be
cancelled if the driver press the OK but
-
ton firmly whilst operating the self
regeneration process.
To Next Page
Loading...
