Revision Date
3/9/2012
Page 1 of 27
KIA Genuine Accessories
Instruction Symbols / Defi nitions
Note: Diffi culty stated above refl ects the minimum level of expertise required to install the accessory
( A ) Customer ( B ) Dealer Technician ( C ) Master Technician
Denotes warnings that may lead to
serious physical injury or vehicle
damage.
Denotes cautions to be taken to avoid
physical injury or electronic component
damage.
Denotes cautions to be taken to avoid
vehicle and component damage.
Denotes quality processes to be
checked prior to moving to the
next step.
Denotes specifi c tools that are neces-
sary to complete the step.
Denotes instructional steps
necessary to complete the
process.
Denotes safety equipment required to be used
such as a mask, goggles, rubber
gloves, and hearing protection.
N
O
T
E
Technical Support
For Authorized Dealers - (800) 667-5176
Hours: 9:00 a.m. - 6:00 p.m. EST Monday - Friday
9:00 a.m. - 3:00 p.m. EST Saturday
Basic Required Hand Tools
1/4” Drive Rachet
Phillips
Screwdriver
Trim Tool Wire Cutter
Pliers
1/4” Drive 10 mm
Socket
Alcohol Cleaner
1/4” Drive Torque
Wrench
1/4” Drive 6”
Extension
Mask
Rubber Gloves Hearing Protection
Googles
Center Fascia
Removal Tool
P/N: 09840-1E100
1/4” Drive 3/8”
Deep Socket
Flat Screwdriver
!
Ensure vehicle is equipped with automatic transmission, power door locks
and power windows. If the vehicle is not equipped with these options, do
not proceed. Ensure vehicle DOES have SMART KEY.
Vehicle Model Sorento (Push Button) Accessory Remote Engine Start
Model Year 2011~ Diffi culty ( B )
KMA Part No. U8560 1U010
Notes to the Installer:
Read the entire installation manual prior to beginning the
installation of the accessory.
Factory wire harness colors are subject to change, please use
the specifi ed pin # in the harness connector to identify the cor-
rect wire for T-Tap installation.
Ensure that the vehicle is properly protected in the area that
the accessory is to be installed.
To prevent vehicle damage, never place tools on top of painted
surfaces, seats, dash pad, console or fl oor carpet / mat.
Always wear appropriate safety gear to include gloves and eye
protection when required.
Prior to disconnecting the negative lead to the battery, note the
AM/FM and satellite set frequencies on the inspection page, if
applicable.
To prevent stress on the remote start wire harness, ensure the
tilt/telescopic steering column is fully extended, if equipped.
Ensure the transportation fuse is properly installed before
performing the function check on page 17.
P/N: 4280402, Rev. A
To Next Page
Need help?
General
