Features of your vehicle
385
Windows
In cold and wet climates, power windows
may not work properly due to freezing
conditions.
The ignition switch or ENGINE START/
STOP button must be in the ON position
for power windows to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock button
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 3
minutes after ignition switch or ENGINE
START/STOP button turned to the ACC
or LOCK position. However, if the front
doors are opened, the power windows
cannot be operated even within the 3
minutes period.
The driver's door has a master power
window switch that controls all the win
-
dows in the vehicle.
If the window cannot be closed because
it is blocked by objects, remove the
objects and close the window.
Whilst driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open position), your
vehicle may demonstrate a wind buffet
-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
one inch. If you experience the noise
with the sunroof open, slightly reduce
the size of the sunroof opening.
Do not install any accessories in the area
of windows. It may impact jam protec
-
tion.
Window opening and closing
You can open and close windows using
the power window switch.
Type A
To open or close a window, press down
or pull up the front portion of the corre
-
sponding switch to the first detent posi
-
tion (5).
Type B - Auto up/down window
(if equipped)
To Next Page
Loading...
