39
5
5
Features of your vehicle Windows
Pressing or pulling up the power window
switch momentarily to the second detent
position (6) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position whilst the window is in
operation, pull up or press down and
release the switch.
To reset the power windows
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Turn the ignition switch or ENGINE
START/STOP button to the ON posi
-
tion.
2. Close the window and continue pull
-
ing up the power window switch for at
least 1 second after the window is
completely closed.
Automatic reversal (if equipped)
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resis
-
tance and will stop upward movement.
The window will then lower approxi
-
mately 30 cm (11.8 in) to allow the object
to be cleared.
If the window detects the resistance
whilst the power window switch is pulled
up continuously, the window will stop
upward movement then lower approxi
-
mately 2.5 cm (1 inch).
And if the power window switch is pulled
up continuously again within 5 seconds
after the window is lowered by the auto
-
matic window reversal feature, the auto
-
matic window reversal will not operate.
The automatic reverse feature for the
window is only active when the "auto up"
feature is used by fully pulling up the
switch. The automatic reverse feature
will not operate if the window is raised
using the halfway position on the power
window switch.
Always check for obstructions before
raising any window to avoid injuries or
vehicle damage. If an object less than 4
mm (0.16 of an inch) in diameter is
caught between the window glass and
the upper window channel, the auto
-
matic reverse window may not detect
the resistance and will not stop and
reverse direction.
The automatic reverse feature is not
activated whilst resetting power window
system.
Make sure body parts or other objects
are safely out of the way before closing
the windows to avoid injuries or vehicle
damage.
To Next Page
Loading...
