Driving your vehicle
1766
Remote Smart Parking Assist (RSPA)
View ( ) button has been pressed
and held, Remote Smart Parking Assist
is in standby. After a whilst, press and
hold the Parking/View ( ) button
again to see if the function works.
The message appears even when the
smart key's battery is low. Check the
smart key battery level.
Limitations of Remote Smart
Parking Assist
In the following circumstances, function
performance to park or exit the vehicle
may be limited, there may be a risk of
collision, or Remote Smart Parking Assist
may turn off. Park or exit the vehicle
manually if necessary.
僅 The parking space is curved or diago
-
nal
僅 There is an obstacle such as a trash
can, bicycle, motorcycle, shopping
cart, narrow pillar etc. near the park
-
ing space
僅 There is a circular pillar or narrow pil
-
lar, or a pillar surrounded by objects
such as fire extinguisher, etc. near the
parking space
僅 There is heavy snow, rain or wind
僅 The vehicle is installed with a snow
chain, spare tyre or different size
wheel
僅 Tyre pressure is lower or higher than
the standard tyre pressure
僅 The road is bumpy
僅 The road is slippery
僅 The parking space is near a vehicle
with higher ground clearance or big,
such as a truck, etc.
僅 Your vehicle is loaded with cargo lon
-
ger or wider than your vehicle or a
trailer is connected to your vehicle
僅 The sensor is mounted or positioned
incorrectly by an impact to the
bumper
僅 The parking space is Inclined
僅 There is a problem with the wheel
alignment
僅 Your vehicle is leaned severely to one
side
僅 Front or rear ultrasonic sensors are
not working properly or does not work
(Refer to "Forward/Reverse Parking
Distance Warning (PDW) (if
equipped)" on page 5-113.)
Remote Smart Parking Assist may not
operate normally under the following
circumstances:
僅 Parking on an inclined road
Park manually when parking onin
-
clines.
To Next Page
Loading...
