Knowing your vehicle
363
1
2
3
4
5
6
7
8
9
Lap/shoulder belt
To fasten the front lap/shoulder
belt:
1. Grasp the buckle and tongue
plate.
2. Slowly pull the lap/shoulder belt
out from the retractor.
3. Insert the tongue plate (
➀
) into the
open end of the buckle (
➁
) until an
audible “click” is heard, indicating
the belt is locked in the buckle.
4. Position the lap portion (
➀
) of the
belt across your lap as LOW ON
THE HIPS as possible to reduce
the risk of sliding under it during
an accident. Adjust the belt to a
SNUG FIT by pulling up on the
shoulder portion (
➁
) of the safety
belt. The belt retractor is designed
to take up excess webbing auto-
matically and to maintain tension
on the belt. For your safety, do not
put any excess slack into the safe-
ty belt at any location.
1GHA2263 1GHA22641GHA2262
To Next Page
Loading...
